To get the most out of your Omniwear garments and keep them looking fresh, it's important to follow proper care guidelines — especially for decorated pieces using DTF Heat Transfer or Embroidery.

Following these instructions will help maintain the quality, longevity, and appearance of your apparel.

 

DTF Heat Transfer (Direct to Film)

Wash and dry inside out

Use cold or cool water only on a gentle cycle

Do not use hot water

Do not use bleach, harsh chemicals, or fabric softeners

DO NOT tumble dry

Avoid drying in direct sunlight

Do not dry clean

Do not iron directly on the print

If needed, iron inside out on low heat

Avoid any high heat contact with the printed area

Important Notes

Allow at least 72 hours (3 days) after pressing before washing — the print continues to cure and fully adhere during this time

With correct care, your DTF prints should last at least 50+ washes

A faint heat press mark may be visible after pressing — this will disappear after 1–2 washes

 

Embroidery

Wash and dry inside out

Use cold or cool water on a gentle cycle

Do not use bleach, harsh chemicals, or fabric softeners

Air dry is preferred, or tumble dry on a delicate cycle

Do not dry clean

Do not iron directly on the embroidered areas

Important Notes

Embroidery should last the life of the garment when properly cared for

Some fading of thread colour or slight puckering may occur over time — this is normal and not a fault

A temporary hoop mark may appear after embroidery — this will disappear after the first or second wash

 

Tip

Always check the label of your specific garment for any extra care instructions. When in doubt — cold, gentle, and inside out is always best and DO NOT tumble dry